DrainMaster Pump

SPECIFICATIONS:     Pro Drain Chief II (Low Speed) by Viking Injector

DIMENSIONS: 7" X 7" w X 6 ^1/2D

ENCLOSURES: Input: 120 VAC, 5 Amps, 60 hrz.
                        Power Cord attached to unit
                        (Optional Battery - powered unit available)

PUMP: Peristaltic type using 1/4" ID Squeeze tubing
           Maximum lift - 20 ft vertical
           Maximum PSA - 40 lbs.
           Feed Rate (low speed) - 4.5 ft. oz. (133 ml.) per minute with 6 ^1/2 foot lift and psuh
           Minimum injection - 1.5 fl. z. ( 44 ml.) @ 20 second run time
           Maximum run time - 3 minutes

PROGRAM TIMER: 24 hour repeat cycle - 1 minute activation interval
                              (optional 7 day timer available)

MOUNTING: Wall mount, double key (drilling template included)
                    Surface mount: Rubber suction feet available

Complete installation hardware and instructions included

Security lock with key

Heavy-duty lid hinge

INSTALLATION: DrainMaster APPLICATION
FEATURES:
Follow manufacturer's installation instructions

To install a DrainMaster 5-gallon pail
1. Remove safety cap from spout on lid of pail
2. Remove black, screw-on resealing cap
3. Pull ring and remove innner spout cap
4. Locate ring of plastic on spout
5. Using a sharp knife cut spout just below the ring
6. Break apart the three sections of snap-together dip tube and snap sections together to make a single 17 ^5/8 tube.
7. Push the assembled tube through the spout, slotted end first (slotted end goes to the bottom of pail, flush side protrudes approximately 3" above the pail lid. This will fit tightly.
8. Insert square plastic piece with compression fitting into protruding end of dip tube.
9. Connect one end of tubing to dip tube compression fitting and other end to compression fitting on supply side of pump.

DrainMaster System